Cnc Slant Bed Lathes are a kind of high precision machinery and equipment, in order to ensure its normal operation and prolong service life, regular maintenance and servicing are required. The following are some suggestions for the maintenance and servicing of the slant guide CNC lathe:
1.Regular cleaning: a lot of metal chips, oil and dust will be produced during the working process, and these dirt will block the heat dissipation holes on the machine and cause the machine to heat up. Therefore, you need to regularly clean the machine and remove the dust that accumulates around the radiator. Cleaning can use special cleaning agents, take care not to damage the surface of the machine coating. 2, lubrication: all parts need lubrication to work properly, so you need to regularly check whether the lubrication is sufficient, and add lubricant in a timely manner. The choice of lubricant should be determined according to the different parts of the machine, it is best to understand the relevant lubrication knowledge before use. 3, check and replace wearing parts: wearing parts include belts, bearings, drive chain, etc.. These wearing parts will wear out during the work process, so they need to be regularly inspected and replaced in a timely manner. Only to ensure the normal operation of wearing parts can ensure the efficient stability of the machine. 4.Regular calibration: It is a kind of high precision Cnc Lathes , in order to ensure its processing accuracy and stability, it needs to be calibrated regularly. For example, a spiral measuring instrument can be used to test the straightness and parallelism of the machine and adjust it according to the test results. 5, pay attention to safety: when using, pay attention to safety. Do not put your hands into the movement area of the machine to avoid danger. At the same time, after stopping use, the power supply and air source should be turned off in time, and the control panel of the machine should be locked to prevent misoperation. To sum up, the maintenance and servicing of the inclined guide CNC lathes requires regular cleaning, lubrication, inspection and replacement of wearing parts, regular calibration and attention to safety. Only after good maintenance and care can we ensure the long-term stable operation and high precision processing of the machine.
